Power Fist 8558777 Manuel De L'utilisateur page 12

V 4.1
MAINTENANCE
WARNING: Any time inspection, maintenance, and cleaning are done:
•
Disconnect the tool from the air resource.
• Empty the magazine completely.
ANTI-DUST CAP
Each tool is packed with an anti-dust cap on the air connector, check it after unpacking.
Keep the anti-dust cap cover the air connector when the tool is not in use.
LUBRICATION
Frequent, but not excessive, lubrication is required for best performance. Oil for the tool added
through the air line connection add will lubricate the internal parts. Do not detergent oil or
additives as these lubricants will cause accelerated wear to the seals and bumpers in the tool,
resulting in poor tool performance and frequent tool maintenance.
1. Disconnect the air supply from the tool to add lubricant.
2. Turn the tool so the air inlet is facing up.
Place 2 to 3 drops of pneumatic fastening tool oil
into air inlet. Do not use detergent oils, oil
additives, or air-tool oils. Do not use detergent oil
or additives as these lubricants will cause
accelerated wear to the seals and bumpers in the
tool, resulting in poor tool performance and
frequent tool maintenance.
3. After adding oil, run too briefly. Wipe off any
excess oil from the cap exhaust.
CAUTION: Lubricate tool only with specified lubricants.
12
2-in-1 Flooring Nailer and Stapler
For technical questions call 1-800-665-8685
8558777