Installation - Zanussi ZEI3921IBA Notice D'utilisation

Labels supplied with the accessories
bag
Stick the adhesive labels as indicated below:
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send this
part (if applicable).
B. Stick it on Guarantee Card and keep this
part (if applicable).

Installation

WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
www.zanussi.com
All manuals and user guides at all-guides.com
B
MOD.
PROD.NO.
0049
SER.NO
03 IT
DATA
MADE IN ITALY
C
MOD.
PROD.NO.
SER.NO.
C. Stick it on instruction booklet.
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Installation of more than one hob
min. 650 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary seals is available at our
Authorised Service Centres. The relevant
installation instructions are supplied within the
kit package.
TYPE
IP20
490 mm
270 mm
9