Turn On The Lift - Handicare AP-450 Manuel Du Propriétaire

Connect the Hand Control
Both the male connector on the cord and the female connector have a latch.
Make sure that the male connector is inserted into the lift connector in the
proper orientation.
1. Line up the latch and latch opening as shown in Figure 3.
2. The latch has to be aligned with the cavity of the connector.
3. Insert the cord connector completely into the connector on underside of the lift until you
hear a click.
4. Pull lightly on the connector to confirm proper connection.
Figure 3: Hand Control connector with latch being inserted into lift connector
Test the Hand Control
Perform a brief test to ensure proper connectivity:
1. Turn on the lift as shown on page 8.
2. Press any button on the Hand Control. The Hand Control screen lights up.
3. Raise and lower the lift using the Up button
4. If the lift moves up and down, the Hand Control is properly connected.
5. If the lift does not move correctly, double-check:
That the lift is on
•
That the Hand Control connector is properly connected
•
That the Hand Control does not display Slack Detected
•
If there are still problems with the lift, contact your local Handicare authorized dealer
for service.
Mount the Hand Control
While the lift is not in-use, the hand control can be mounted on to the top of the lift using the
angled slider. Align the hand control with the slider on the cover, and slide the hand control
down. To remove, pull the hand control up and over until it is disengaged from the slider.

Turn On the Lift

Before using the AP-450 lift system, check the lift, track, and sling for any
unusual wear or damage. Refer to the owner's manual for each piece of
additional equipment to determine what should be checked. If anything
looks unusual, contact your local Handicare dealer or your local
Handicare business development manager before use. Failure to check
the lift could result in damage to the lift or serious injury to the operator
or the individual being lifted.
1. Press any button on the Hand Control to turn the lift on. The indicator light on lift
membrane lights green and the display screen on Hand Control displays [Ready].

and Down button
7

.