Spare Parts; Ordering; Declaration Of Conformity - Bosch Rexroth 1 827 414 297 Mode D'emploi

Spare parts/Declaration of conformity
20
6

Spare parts

7

Declaration of conformity

In accordance with the explosion protection guideline 94/9/EC.
We hereby confirm that the above mentioned valve solenoids from Bosch
Rexroth AG conform with the requirements set out by the European Council in
the guidelines to harmonize the legal provisions of the member states for
equipment and protection systems for use in areas subject to explosions (94/
9/EC) as set out in the current version.
This declaration applies to all models that are manufactured according to the
production documentation that is a part of this declaration.
The solenoids are electric components and may only be installed by trained
personnel; the relevant regulations must be observed.
Valve solenoid 1 827 414 297 - 1 827 414 312
II 2G EEx m II T5
The prototype test approval numbers PTB 03 ATEX 2081 X and PTB no.
Ex-03 IEC 2082 X are applicable to the solenoids.
The conformity to PTB no. Ex - 03 ATEX N 033 has been issued by the PTB
(Physikalisch-Technische Bundesanstalt) (registration office number 0102).
The valve solenoid is a group II encapsulated electrical device that is suitable
for use in 2G and 3D atmospheres (see the imprint for the temperature class).
The CE marked device fulfils the following standards: see next page.
6.1

Ordering

You can order spare parts using the ID number
located on the device (imprint, nameplate).
IEC Ex m II T5
Bosch Rexroth
II 3D IP65 T95°C