Tooling - Wezag WDT UP 14 Z Mode D'emploi

7

Tooling

DANGER
Due to the risk of hand or finger injury, never try to reach into the machine before having
+
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard and the dies.
CAUTION
The pneumatic Crimp Machine UP 14 Z may only be set up and operated in perfect
+
technical condition, observing all the safety regulations and considering any possible
dangers.
The crimp machine is only allowed to be used with mounted dies and safety guard.
+
When working with the pneumatic Crimp Machine UP 14 Z, do not wear loose clothing,
+
jewellery or long, loose hair that can get caught in the pneumatic Crimp Machine UP 14 Z.
Work with caution.
+
Only one person is allowed to work on or with the machine.
+
Only trained personal are allowed to work on or with the machine.
+
Assure free access to the operating elements of the machine, especially the foot pedal.
+
It is only allowed to work with the specified air pressure.
+
1. Disconnect pneumatic supply.
2. Remove the locator holding fixture 2
and/or the safety guard 3.
3. Remove special screws of die set 1.
4. Slide the upper and lower die in the
adapter and tighten the screws.
INFORMATION
Control the right position of the die halves! The size of the profile should be in line!
+
BDA UP 14 Z – 03/15 – REV. 0
3
1
2
Page 38 / 71
Fig. 7.1