Release Button; Transport And Installation; Transport; Installation - Wezag WDT UP 14 Z Mode D'emploi

4.5

Release Button

In case of jammed jaws caused by operation
or handling errors
terminals the jaws can be opened as follows:
Press Release Button.
+
5

Transport and Installation

5.1

Transport

The weight of the pneumatic Crimp Machine UP 14 Z is approx. 13 kg.
CAUTION
During transport and installation of the machine wear suitable safety shoes.
+
ATTENTION
Tubes must not be damaged.
+
5.2

Installation

ATTENTION
Position the pneumatic Crimp Machine UP 14 Z on a flat surface and assure the stability of
+
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use.
Assure an appropriate table height. The table height is depending on the position of the
+
operator, (work in sitting or standing position) according to prEN 894-4:2004, Table A.1.
Assure an appropriate illumination of the working place. (EN 1837:1999 – chapter 4.2: "The
+
general value of illumination has to be 500 lx [...]").
INFORMATION
To reduce production noise or vibration, the machine can be placed on an insulating rubber
+
mat.
Place the foot pedal on the floor. No other place is allowed!
BDA UP 14 Z – 03/15 – REV. 0
or wrongly placed
Fig. 4.4
Page 35 / 71