Wezag WDT UP 14 Z Mode D'emploi page 30

Tubes must not be damaged.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
+
movable, so that the operator has the possibility to change his position for ergonomic and
production needs.
Do not lay the foot pedal in aisles or walk ways.
+
Assure free access to the operating elements of the machine, especially the foot pedal.
+
Before starting maintenance, disassembly or repair work, the crimp machine must be
+
disconnected from air supply.
Maintenance work may be performed only by authorized and properly trained personnel.
+
Due to the risk of hand or finger injury, never try to reach into the machine before having
+
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard and the dies.
Before commissioning the machine, it is always important to check whether all safety
+
devices, especially the safety guard and the die set, are installed and are functioning
correctly.
Check the release button before starting the work on the crimp machine. In the case of
+
imminent danger immediately press the release button. The release button must be within
the direct reach of the operator. It must not be covered.
Exercise caution at any time when the pneumatic Crimp Machine UP 14 Z is switched on.
+
The pneumatic Crimp Machine UP 14 Z is not allowed to be used without a installed die set
+
and safety guard.
The larger opening of the safety guard is only allowed to be used with mounted locator
+
holding fixture and mounted locator.
The pneumatic Crimp Machine UP 14 Z may only be set up and operated in perfect
+
technical condition, observing all the safety regulations and considering any possible
dangers.
The crimp machine is only allowed to be used when it is in complete functional condition.
+
If you suspect that the machine cannot be operated safely, it must be switched off and
+
secured against anyone accidentally switching it on.
In cases of a machine malfunction, production must be stopped and the malfunction must
+
be fixed before continuing work with the machine.
Work with caution.
+
Only one person is allowed to work on or with the machine.
+
Only trained personal are allowed to work on or with the machine.
+
It is only allowed to work with the specified air pressure.
+
When working with the pneumatic Crimp Machine UP 14 Z, do not wear loose clothing,
+
jewellery or long, loose hair that can get caught in the pneumatic Crimp Machine UP 14 Z.
Disconnect the pneumatic Crimp Machine UP 14 Z from the air supply before attempting
+
any maintenance work. Due to the risk of hand or finger injury, never try to reach into the
machine before having assured that the machine is disconnected from the air supply.
The machine can only be depressurizes by disconnecting the machine from the main air
+
supply.
For maintenance work wear adequate protective gloves and safety glasses. Pleas pay
+
attention to the safety instructions in the "safety data sheet" of the grease.
For the transport of the machine wear suitable safety shoes.
+
BDA UP 14 Z – 03/15 – REV. 0 Page 30 / 71