Taring; Pre-Tare Function; Plus/Minus Weighings - KERN DE6K0.5A Mode D'emploi

6.3

Taring

Switch-on the balance using the
Put the tare vessel on the weighing plate and press the
display goes to „0". The weight of the container is now internally saved.
If after finishing the weighing process the
anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.

6.4 PRE-Tare function

Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.
Switch-on balance using the
Put tare vessel on the weighing plate and press the
flashes on the display. By actuating the
plate is saved as PRE-Tare weight.
To switch off this function, unload the weighing plate and press the
until „PtArE" flashes on the display. Then press the
weight is deleted.

6.5 Plus/minus weighings

For example unit weight control, fabrication control etc.
Switch-on the balance using the
Put the nominal weight on the weighing plate and tare to „0" using the
Remove the nominal weight.
Put the test objects subsequently on the weighing plate, the respective deviation from
the nominal weight is displayed with the respective sign to „+" and „-".
According to the same procedure also packages with the same weight can be
produced, referring to a nominal weight.
Back to weighing mode by pressing the
18
key and wait for the „0" display.
key, is pressed again, „0" appears
key and wait for the „0" display.
key, the current weight on the weighing
key and wait for the „0" display.
key.
key. The balance
key 6 times until „PtArE"
key 6 times,
key. The stored PRE-Tare
key.
DE-BA-e-1657