Cleaning And Maintenance - Krups BW730 Manuel

KR_KETTLE_BW730_NAFTA_NC00111276_Mise en page 1 25/05/12 16:40 Page8
English
Notes:
Always remove the kettle from the base before filling it with water.
Never use without water or fill with liquids other than water. When filling the kettle, take care to not
expose the electrical connections at the bottom of the kettle to water.
You can also fill the kettle with water through the spout.
Do not fill the kettle beyond the maximum level, or below the minimum level marked on the water level
indicator (h) If the kettle is overfilled, boiling water may splash outside of the kettle.
Always use the kettle with its lid closed.
3- Place the kettle on its base.
4- Press the On/Off switch (i) located at the bottom of the kettle under the handle (g). (fig. 4). The blue
LED light on the water windows (h) will switch on. The boiling cycle starts.
5- At the end of the boiling cycle, the blue LED light will automatically turn off and the On/Off switch (i)
will go back to the Off position.
Note: At any time during the boiling cycle, you can manually stop the boiling cycle, simply by lifting the
On/Off switch (i) to its Off position.
6- Remove the kettle from its base before pouring.
7- To avoid the risk of splashing, pour boiled water slowly and don't over-tilt the kettle.
CAUTION: A dry boil cut-off system will automatically switch the kettle off.

5. CLEANING AND MAINTENANCE

DO NOT LEAVE WATER IN THE KETTLE AFTER USE.
EMPTY THE KETTLE AFTER EACH USE TO REDUCE ACCUMULATION OF LIMESCALE
DEPOSITS.
To clean the kettle and base
Always unplug the base and allow the kettle to cool before cleaning.
Avoid exposing the base or the bottom of the kettle to excess water. To protect against risk of electrical
shock, do not immerse the base in water or any other liquid, or place under running water to clean.
Wipe clean with a damp sponge and a small amount of gentle dishwashing liquid if necessary. Never
clean with harsh or abrasive cleaners or sponges. Dry all parts carefully before next use.
To clean the limescale filter ©
Always unplug the base and allow the kettle to cool before cleaning.
The limescale filter is a removable mesh filter in the spout of the kettle. This filter does not treat or
remove the scale from the water, it traps the scale particles from being poured out.
With very hard water, the filter may need to be cleaned as often as 10-15 uses. If the filter is wet, run
under lukewarm water to remove particles. If filter is dry, brush gently to remove particles. To avoid
damaging the mesh, do not scrub the filter.
To remove excessive scale, descale as described below.
8
(fig. 5)