Troubleshooting - Bosch Tassimo TAS 65 Série Notice D'utilisation

32

Troubleshooting

Problem
Appliance not working;
no symbols light up.
I can't read the LC-
display because it is in
the wrong language.
Machine brews but no
drink dispensed.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
O
Automatic mode
skipped, appliance
goes straight to
N
Manual mode.
More Customer Service information is available online at www.tassimo.com
Robert Bosch Hausgeräte GmbH
TAS 65_85 EU 090618.indd 32
The following table provides solutions for problems and glitches
that may arise as you use your TASSIMO machine. If you do not
after troubleshooting please contact our customer service
department
!
Note: If piercing unit is missing, it may be purchased from
TASSIMO careline 08 00 032 88 33 or at www.tassimo.com.
Possible cause
There is no power supply.
You may want to change the
language setting.
The water tank was removed
during the brewing process or
there is air in the system.
stuck.
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
Solution
Check that the appliance is
properly plugged into the
power supply.
Please proceed as described
displays".
Replace the water tank in the
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
Clean the water tank and
Check if T DISC has been
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline.
08 00 032 88 33.
Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start /stop
button.
en
19.06.2009 08:26:08