DS Produkte CM5013B-GS Manuel page 18

EN
Never immerse the device and the mains connecting cable in
■
water or other liquids and ensure that they cannot fall into water
or become wet.
The device must always be disconnected from the mains when
■
it is left unattended and before assembling, disassembling, fi lling
or emptying the water tank or cleaning it.
In the interest of your own safety, inspect the device for damage
■
each time before you use it. Use the device only if it is in work-
ing order.
Do not make any modifi cations to the device. Do not replace the
■
mains cable yourself. If the device or the mains connecting ca-
ble of the device is damaged, it must be replaced by the manu-
facturer, customer service department or a specialist workshop
in order to avoid any hazards.
It is essential to follow the instructions in the "Care and Storage"
■
chapter.
DANGER – Risk of Electric Shock
■ Use the device only in closed rooms.
■ Do not use the device in rooms with high humidity.
■ Should the device fall into water, switch off the power supply immediately. Do not at-
tempt to pull it out of the water while it is still connected to the mains power!
■ Never touch the device and the mains connecting cable with wet hands when these
components are connected to the mains power.
■ Make sure that the steam which emerges is not aimed directly at electrical devices
and equipment containing electrical components.
WARNING – Danger of Injury
■ Danger of suffocation! Keep children and animals away from the packaging mate-
rial.
Danger of scalding from heat, hot steam or condensation!
■ Avoid coming into contact with the rising steam. Do not open the water tank lid
during the brewing process.
■ Do not take out the portafi lter during the brewing process. The portafi lter gets hot
during use.
■ Be careful when removing the portafi lter after operating the device. There may
still be hot water remaining in / on the portafi lter!
■ Never pour water into the water tank when the device is switched on or during the
brewing process. Allow the device to cool down before fi lling it again.
■ Do not move the device during the brewing process.
20