Hitachi AXM10E Mode D'emploi page 48

C. Presetting stations (using the remote control unit)
20 stations in 2 band FM/MW can be preset
Notes:
• The previous stored station is erased when a new station is stored, because the new
station's frequency replaces the previous frequency in memory.
• When listening to a MW broadcast, noise may be heard if the remote control unit is
used.
• All preset stations will be erased when the power cord is disconnected or a power
failure occurs. In such cases, store the stations again.
D. Frequency step of MW band
To tune to your local MW station, you can select either 9 kHz or 10 kHz as the fre-
quency step. By default, the factory setting for the unit is at 9 kHz step.
To switch to the required frequency step:
1) Make sure the unit is at MW band in TUNER mode.
2) To select 9 kHz frequency step – press and hold the BAND button while pressing
)/f button.
3) To select 10 kHz frequency step – press and hold the BAND button while pressing
g/( button.
The set will remain at the selected frequency step setting, until item 2 or 3 is pressed
again.
E. RDS Button (using the remote control unit)
Use this button to automatically tune to stations using the radio data system. There
are program type identification (PTY), clock time (CT) and radio text (RT) functions.
DISPLAY
• RDS (Radio Data System) When the RDS button is pressed, a station is being
searched for and automatically tuned in. The "RDS" indicator lights up and the
station's name is displayed on the frequency display.
• PTY (Program Type) This indicator lights up when the type of RDS program is
specified.
• RT (Radio Text) This lights when the RT mode and the RT message is displayed.
REMOTE CONTROL
CT PTY PANEL RDS
046-050(Eng) AX-M10E
All manuals and user guides at all-guides.com
CT button
Use this to correct the time of the clock on the AX-M10. Press this
button when the time service of an RDS station is received
correctly. "CT ON" is displayed for 2 seconds and the AX-M10's
clock is corrected. Press the CT button twice, and "CT OFF" is
displayed.
The clock can be adjusted manually in "CT OFF" mode.
RDS button
Use this to automatically tune to stations using the radio data
system.
48
48
English
7/26/02, 5:19 PM