SOMFY MAESTRIA+ 50 RTS Notice page 5

Follow the following steps for set-up:
1) Preprogramming of the Somfy local control point (§
2) Checking the rotation direction (§
3) Setting the end limits (§
4) Setting advanced functions (§
5) Programming of the Somfy local control point (§
2. 3. 2. Preprogramming of the Somfy local control point
- Simultaneously press the "Up" and "Down" buttons: The driven
product moves up and down briefly.
This control point is now preprogrammed in the drive.
Preprogramming is lost if power to the drive is switched off before
the control point is registered.
2. 3. 3. Checking the rotation direction
1) Press the "Up" button:
• If the driven product raises, the rotation direction is correct.
• If the driven product lowers, the rotation direction is incorrect.
Press the "my" button until the driven product moves up and down
briefly: the rotation direction has now been modified.
2) Press the "Up" button to check the rotation direction.
2. 3. 4. Setting the end limits
The procedure used to set the end limits depends on the equipment of the driven product (see table below).
Pressing and holding the "Up" or "Down" buttons causes the driven product to raise or lower continuously.
Pressing the "Up" or "Down" buttons briefly causes the driven product to raise or lower briefly.
Available devices
a
Top stop Catching system at lower end
None Manual
✓
✓
✓ ✓
✓
*Automatic
** This step is especially suitable for "ZIP screens" or for any other specific driven product with a heavy load bar and
a top stop.
Copyright © 2017 Somfy SAS. All rights reserved.
2. 3. 3
)
2. 3. 4
)
2. 3. 5
)
b c
Heavy
limit load bar
*Auto.
✓
✓
✓
✓
✓
2. 3. 2
)
2. 3. 6
)
1)
2)
a
Steps to be
performed
See E1
See E2
See E3**
See E4
See E5
Non contractual images
0.5
S
The rotation
direction is
b
EN
correct
c
5