Step 7 Alternate Anti-Tip Procedure; Step 8 Adjust Door Swing - Monogram ZIP360NN Instructions D'installation

Installation Instructions- Stainless Steel Installation
STEP 7 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
If the anti-tip bracket cannot be used, this alternate
procedure may be used to secure the refrigerator
against tip-over
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.

STEP 8 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 115°
or 90° opening. Skip this step if door opening is
satisfactory for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 115° position.
Pin Location
for 90°
Door Swing
• Reinstall the wire cover trim.
36
Remove
Wire Cover
Trim Screws
Pin Location
as Shipped 130°
Door Swing
Pin Location
for 115°
Door Swing
31-1000451 Rev. 0