Changement De Position Des Orifices - Parker M5AS Mode D'emploi

Catalogue HY29-0037-M1/FR
conversions

3 . 3 . cHAngeMenT De PoSiTion DeS oriFiceS :

6 . Remettre en place les
quatre vis.
7 . Serrer au couple prescrit
ci-dessous.
a) Always check if the shaft rotates. (a slight resistance due to the spring loaded vanes is
!
normal). Otherwise, please go back to the previous step.
b) Check the porting configuration (see table page 30).
c) Tighten the 4 screws step by step to avoid damaging the seals.
1
3
d) Always check if the shaft rotates.
If not, disassemble and go back to the previous step.
couPle De SerrAge : 100 nm
Moteurs hydrauliques, cylindrée fixe
M5AS - M5ASF, moteurs à palettes Denison
4
2
26 Parker Hannifin SAS
VPDE, Denison Vane Motors
Vierzon - France