Montage - Parker M5AS Mode D'emploi

Catalogue HY29-0037-M1/FR
conversions
3 . 1 . DeMonTAge / MonTAge
3 . 1 . d MonTAge :
Place the quad seal on to the
end cap. (use some grease
to make sure the seal stays
in its position).
17 . Position the end cap.
LUBRIFIER
AVEC
Moteurs hydrauliques, cylindrée fixe
M5AS - M5ASF, moteurs à palettes Denison
18
Check that the seal remains
!
correctly placed on the end
cap.
Be careful with the dowel
!
pin positioning.
a) Always check if the shaft
!
rotates.
If not, disassemble and go
back to the previous step.
b) Check the porting confi-
guration (see table page
30).
c) Tighten the 4 screws step
by step to avoid damaging
the seals.
1
3
d) Always check if the shaft
rotates.
If not, disassemble and go
back to the previous step.
couPle De SerrAge : 100 nm
Parker Hannifin SAS
VPDE, Denison Vane Motors
Vierzon - France
4
2