GEZE TS 5000 L-E-ISM VPK Instructions De Montage page 14

Mounting and fixing
6.6 Mounting wire rope
Lay the end nipple of the Bowden cable with 90° deflection through regulating screw R until it stops (1.).
X
Clamp wire rope with screw S (2.).
X
Lay the wire rope and wire rope sleeve through the cable fitting and regulating screw at adjustment piece (3.).
X
Open moving leaf to max. width. It should be possible to move the wire rope sleeve freely without tensions. If
X
necessary, move adjustment piece until wire rope sleeve can be moved freely.
Fix wire rope sleeve using cable fitting (5.).
X
Fix adjustment piece on moving-leaf end with setscrews (6.).
X
Lay wire rope through adjustment piece on fixed-leaf end and wire rope sleeve on fixed-leaf end (7.).
X
Adjust adjustment piece on fixed-leaf end to dimension 85 mm and fix it with setscrew (8.).
X
Loosen clamping screw (1.).
X
Thread wire rope with wire rope redirection into oblong hole (2.).
X
Thread past the clamping screw and guide out of the oblong hole (3.).
X
Tension wire rope so that the IS valve (fig. 6.6.1) at door closer on moving-leaf end cannot be operated (4.).
X
Tighten clamping screw (5.).
X
Mount trigger lever (6.).
X
Shorten wire rope to an excess of 30–50 mm to the outer edge of the guide rail (7.).
X
GB 6
TS 5000 L-E-ISM VPK
Fig.: 6.6.1
Fig.: 6.6.2