6 Care and maintenance
6.1 Maintenance
Regular product maintenance is not re-
quired.
6.2 Replacing the battery
1. Replace the battery if the MASTER no
longer responds to the remote control.
A
2. Press the lever at the side of the bat-
tery holder and pull out the batter
holder.
3. Remove the old battery.
4. Dispose of the old battery. (→ Page 37)
A
B
5. Insert the new CR2025 battery (3 V) as
shown in the image.
6. Place the battery holder containing
the new battery back into the remote
control.
– The remote control is ready for oper-
ation.
0020236700_05 Operating instructions
B
Care and maintenance 6
6.3 Caring for the product
▶
Clean the casing with a damp cloth and
a little solvent-free soap.
▶
Do not use sprays, scouring agents,
detergents, solvents or cleaning agents
that contain chlorine.
7 Decommissioning
7.1 Temporarily decommissioning
the product
1. Press the lever at the side of the bat-
tery holder and pull out the batter
holder.
2. Remove the battery.
3. Place the empty battery holder back
into the remote control.
7.1.1 Replacing the product
1. Replace the remote control unit.
2. Start up the new remote control.
(→ Page 34)
7.2 Recycling and disposal
▶
The competent person who installed
your product is responsible for the dis-
posal of the packaging.
If the product is labelled with this
mark:
▶
In this case, do not dispose of the
product with the household waste.
▶
Instead, hand in the product to a collec-
tion centre for waste electrical or elec-
tronic equipment.
If the product contains batteries that
are labelled with this mark, these batteries
may contain substances that are hazard-
ous to human health and the environment.
▶
In this case, dispose of the batteries at
a collection point for batteries.
37