Setting Up The Master-Slave On The Var 60/1 Dw - Vaillant VAZ RC Notice D'emploi

4.4 Setting up the MASTER-SLAVE
on the VAR 60/1 DW
6
5
4.4.1 Initialising the product
1. Switch on the product.
◁
The LED lights up for 10 seconds.
2. Press the button for eco mode (1) five
times while the LED is lit up.
◁
The LED lights up and remains lit.
◁
The ventilation unit has been initial-
ised.
3. Switch off the ventilation unit.
4.4.2 Assigning the code
Applicability: VAZ RCW
1. Switch on the first ventilation unit.
◁
The ventilation unit waits until you
enter the eight-digit code.
◁
The LED on the ventilation unit
flashes red and white.
2. Use the six buttons (1) to (6) to select
an eight-digit code, but do not use the
same number eight times.
3. Note down the code.
0020236700_05 Operating instructions
1
4. Enter the code.
2
◁
The LED on the ventilation unit
3
flashes red: The code is assigned to
the ventilation unit.
▽
The LED on the ventilation unit
lights up red for 3 seconds: The
code that is entered is invalid.
– If the LED on the ventilation unit
5. Set up the ventilation unit as the
4
MASTER. (→ Page 35)
6. Switch on the closest ventilation unit
and enter the code.
7. Set up this ventilation unit as the
SLAVE. (→ Page 35)
8. Repeat steps 5 and 6 for all other vent-
ilation units.
4.4.3 Setting up a ventilation unit as
the MASTER
Applicability: VAZ RCW
▶
Press the button for eco mode (1) twice
in order to set up the ventilation unit as
the MASTER.
4.4.4 Setting up a ventilation unit as
a SLAVE
Applicability: VAZ RCW
Conditions: The ventilation unit is on the opposite
side to the MASTER
▶
Press the button for ventilation (5) twice
in order to set up a ventilation unit as a
SLAVE.
Operation 4
Note
The code is required when you
set up other ventilation units.
flashes red and white again, you
can enter a new code.
Note
Only one ventilation unit may be
set up as the MASTER.
35