General Technical Data - GE AF-600 FP Guide Rapide

Specifications
8 Specifications

8.1 General Technical Data

Mains supply (L1, L2, L3):
Supply voltage
Mains voltage low / mains drop-out:
During low mains voltage or a mains drop-out, the drive continues until the intermediate circuit voltage drops below the
minimum stop level, which corresponds typically to 15% below the drive's lowest rated supply voltage. Power-up and full torque
cannot be expected at mains voltage lower than 10% below the drive's lowest rated supply voltage.
Supply frequency
Max. imbalance temporary between mains phases
True Power Factor ()
Displacement Power Factor (cos) near unity
Switching on input supply L1, L2, L3 (power-ups) ≤ 7.5 kW/10 HP and below
Switching on input supply L1, L2, L3 (power-ups) ≥ 7.5 kW/10 HP and below
Switching on input supply L1, L2, L3 (power-ups) ≥ 110 kW/150 HP and above
8 8
Environment according to EN60664-1
The unit is suitable for use on a circuit capable of delivering not more than 100.000 RMS symmetrical Amperes, 240/480/600 V
maximum.
Motor output (U, V, W):
Output voltage
Output frequency
Switching on output
Accel/Decel Times
*
Dependent on power size.
Torque characteristics:
Starting torque (Constant torque)
Starting torque
Overload torque (Constant torque)
*Percentage relates to the adjustable frequency drive's nominal torque.
Cable lengths and cross sections:
Max. motor cable length, screened/armoured
Max. motor cable length, unscreened/unarmoured
Maximum cross section to control terminals, rigid wire
Maximum cross section to control terminals, flexible cable
Maximum cross section to control terminals, cable with enclosed core
Minimum cross section to control terminals
32
AF-600 FP Quick Guide
200-240 V ±10%, 380-480 V ±10%, 525-600 V ±10%, 525-690 V ±10%
DET-759A
3.0% of rated supply voltage
≥ 0.9 nominal at rated load
maximum twice/min.
maximum once/min.
maximum once/2 min.
overvoltage category III / pollution degree 2
0–100% of supply voltage
maximum 110% for 1 min.
maximum 135% up to 0.5 sec.
maximum 110% for 1 min.
2
1.5 mm /16 AWG (2 x 0.75 mm
1 mm
0.5 mm
50/60Hz ±5%
(> 0.98)
0–1000 Hz*
Unlimited
1–3600 sec.
*
*
*
150 m
300 m
2
)
2
/18 AWG
2
/20 AWG
2
0.25 mm