Installation Of The Co; General - Zehnder CO2 Sensor Manuel D'installation

Masquer les pouces Voir aussi pour CO2 Sensor:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75

6. Installation of the CO

6.1 General

The CO
RF Sensor is always set as the controller.
2
The CO
RF Sensor must be paired with the ventilation unit before first use.
2
Within 30 seconds during installation, press the operating button of
Sensor to confirm a setting.
the CO
2
The combination of a CO
R1.8.0 or higher on said ventilation unit.
The combination of a CO
ComfoSense firmware v27 or higher.
6.2 Installation of the CO
Figure 6.1 ­ Front of the CO
1. Activate the pairing mode in the ventilation unit:
■ ComfoAir E/ComfoAir PRO/ComfoFan S/CMFe/RPMe/VPMe/KPMe/ComfoAir
160/180/200/350/450/550 with RF receiver: isolate power to the ventilation unit, wait
at least 5 seconds, then turn the power back on;
■ ComfoAir Q with RF receiver: activate the menu on the ventilation unit via
ADVANCED. SETTINGS > RF SETTINGS > START RF PAIRING;
■ ComfoSense C: on the ComfoSense C, activate the menu via ADVANCED SETTINGS
> RF PAIRING > START.
■ For other ventilation devices, please refer to the corresponding manual.
42 - EN
RF Sensor
2
RF Sensor v2.03 with a ComfoAir Q requires firmware
2
RF Sensor v2.03 with a ComfoSense C requires
2
RF Sensor
2
Sensor
2
Legend
1. Top LED
2. Middle LED
3. Bottom LED
4. Operating button
5. CO
LED
2

Publicité

Table des Matières
loading

Table des Matières