C Sensor; General - Zehnder CO2 Sensor Manuel D'installation

5. Installation of CO

5.1 General

Programme the CO
ventilation unit.
When the CO C Sensor is connected to a ventilation system, it can be used immediately.
2
As standard, the CO
Sensors. When in deviation from this:
1) more than 8 CO
2) another CO setpoint than 1050 ppm is required and/or
2
3) if several different CO
the installer menu of the ventilation unit or of the ComfoControl App.
It is possible to disable the operation of ventilation modes on the device, so that
the CO C Sensor functions only as a sensor. This can be set per sensor in the
2
installer menu of the ventilation unit and of the ComfoControl App.
Figure 5.1 ­ Front of the CO
2
C Sensor with the ComfoControl App or via the display of the
2
control works with a CO
2
Sensors are connected; and/or
2
setpoints are required, the sensor settings must be adjusted in
2
Sensor
2

C Sensor

setpoint of 1050ppm for all connected CO
2
Legend
1. Top LED
2. Middle LED
3. Bottom LED
4. Operating button
5. CO LED
2
2
EN - 41