Mounting Of The Coc And 0-10V Sensor; Mounting Of The Co Rf Sensor - Zehnder CO2 Sensor Manuel D'installation

4.2 Mounting of the CO
Sensor
All letters in this section refer to the
previous images.
1. At the on­wall sensor, attach the
surface­mounted box (Figure 4.3, pos.
Z) on the wall using the dowels (not
shown) and screws (not shown).
2. Attach the wall frame (Figure 4.1,
4.2 and 4.3, pos. A) with the screws
(Figure 4.1, 4.2 and 4.3, pos. F) on
the wall, the surface­mounted box
(Figure 4.3, pos. Z) or the mounting
plate.
3. Pass the cables through the desired
design frame (Figure 4.1, pos. X) and
set the size of the window (Figure 4.1,
pos. D).
Read the corresponding manual
before connecting to the
ventilation unit.
4. Connect the cables to the CO
(Figure 4.1, 4.2 and 4.3, pos. B).
5. Connect the cables to the ventilation
unit.
6. Use the screws (Figure 4.2 and 4.3,
pos. E) to secure the CO
including the design frame (Figure 4.1,
pos. X) and the window (Figure 4.1,
pos. D), to the wall frame (Figure 4.1,
4.2 and 4.3, pos. A).
Always mount the plastic cover by
hand.
7. Push the cover (Figure 4.1, 4.2 and
4.3, pos. C) onto the CO
(Figure 4.1, 4.2 and 4.3, pos. B).
40 - EN
C and 0-10V
2
Sensor
2
Sensor,
2
Sensor
2
4.3 Mounting of the CO
All letters in this section refer to the
previous images.
1. Switch off the mains power.
2. At the on­wall sensor, attach the
surface­mounted box (Figure 4.3, pos.
Z) on the wall using the dowels (not
shown) and screws (not shown).
3. Attach the wall frame (Figure 4.1,
4.2 and 4.3, pos. A) with the screws
(Figure 4.1, 4.2 and 4.3, pos. F) on
the wall, the surface­mounted box
(Figure 4.3, pos. Z) or the mounting
plate.
4. Pass the cables through the desired
design frame (Figure 4.1, pos. X) and
set the size of the window (Figure 4.1,
pos. D).
Read the corresponding manual
before connecting to the
ventilation unit.
5. Connect the cables to the CO
(Figure 4.1, 4.2 and 4.3, pos. B).
6. Use the screws (Figure 4.2 and 4.3,
pos. E) to secure the CO
including the design frame (Figure 4.1,
pos. X) and the window (Figure 4.1,
pos. D), to the wall frame (Figure 4.1,
4.2 and 4.3, pos. A).
Always mount the plastic cover by
hand.
7. Push the cover (Figure 4.1, 4.2 and
4.3, pos. C) onto the CO
(Figure 4.1, 4.2 and 4.3, pos. B).
RF Sensor
2
Sensor
2
Sensor,
2
Sensor
2