Festool MFT 800 Mode D'emploi page 8

1
Technical data
Table dimensions (width x length)
Table height - with foldaway legs
- without foldaway legs
max. working width
- with FS 800 guide rail (mounted crosswise)
- with FS 1080 guide rail (mounted crosswise)
- with FS 1400 guide rail (order no. 482975)
mounted lengthwise
max. workpiece thickness
Weight
2 Scope of delivery
1 Table (1.1) consisting of: profi le fra-
me, angular feet, perforated panel,
foldaway legs
1 support unit (1.2)
1 FS 800 or FS 1080 guide rail (1.3)
1 swivel unit (1.4)
1 swivel segment (15) with hexagon
key (1.6)
1 stop ruler (1.7)
1 additional clamp for stop ruler (1.8)
1 sliding stop AR-MFT (1.9)
1 defl ector (1.10)
3 Correct use
The multifunction table has been designed
for safe and precise sawing and routing with
Festool electric tools.
Workpieces can be safely clamped on the
worktop using the clamping systems avai-
lable from the accessories program, making
the table a workbench for numerous jobs
such as planing, sanding, carving, etc.
4 Erection and assembly
The attachments can be fi tted on the multi-
function table at various positions, resulting
in various working positions.
In the standard working position, the ope-
rator stands on the long side of the table
(Fig. 4).
In these operating instructions, this side of
the table will be referred to as the "front".
MFT 800
590 x 725 mm
820 mm
205 mm
510 mm
625 mm
90 mm
20 kg
4.1 Erection
Screw the grip knobs (4.3) in up to the stop.
Unfold foldaway legs and lock in position with
the grip knobs at the joints.
Uneven surfaces can be compensated by
turning the cap (4.1) on the rear right leg.
The angular feet (4.4) have rubber caps
on their underside so that the table stands
fi rmly even when the legs are folded away
(illustration on front cover).
4.2 Fitting the guide rails
Corresponding stops (7.4 + 6.1) have been
provided in the longitudinal profi le on the
front and rear of the table in the works for
the recommended working positions.
The swivel unit (1.4/6.2) is mounted on the
rear long side, the support unit (1.2/4.2) on
the front long side.
The units are inserted into the profi le groove
from the left up to the stop with the height
adjustment (7.3) and the rotary knob (7.1)
released, and are then clamped with the
rotary knob (7.1).
Both units can be adjusted free from play
in the profi le groove by turning the setting
screws in the tongue with a size 2.5 hexa-
gon key.
Push the metal parts up and lock in position
by pressing the clamping lever (7.3) down
for better access to the two units.
The clamping effect can be adjusted at the
screws (7.2) as required.
To fi t the guide rail, place on the feather key
(6.3) so that the rail rests on the support
plate (the Festool lettering can be read from
the right) and the feather key is fully in the
groove.
8
MFT 1080
724 x 1164 mm
820 mm
205 mm
625 mm
1085 mm
90 mm
33 kg