Festool MFT 800 Mode D'emploi page 10

6.2 Screw clamp FSZ, order no.
489570
Workpieces can be clamped vertically on the
working table with the FSZ screw clamps.
Insert the clamping bow of the screw clamp
into a hole in the perforated plate from above
and clamp the workpiece from above with
the pressure pad.
6.3 Length stop MFT-LA, order no.
488564
Routing or sawing work with a constant
distance to the guide rail can be simply
and easily carried out using the length stop
MFT-LA. The MFT-LA can be fi tted at any
point around the profi le frame.
Fit the stop on the right side of the table to
cut parts of equal length to size or for routing
at a constant distance (Fig. 9).
The stop can be swivelled out of the way
after adjustment, enabling unhindered pro-
cessing of the workpiece.
6.4 Sliding stop AR-MFT (order no.
490555; 1 included in delivery)
One or several sliding stops can be slid onto
the stop ruler and clamped with the clamping
lever (7.8) in an arbitrary position.
The stop plate (7.9) can be away swung to
put the sliding stop out of action.
7 Retrofi tting the FST 660/85
The angle stop MFT-WA (order no. 488563)
and the clamping systems described in sec-
tions 6.1 and 6.2 can also be used with the
Festool FST 660/85 router/saw table if the
worktop is replaced by the perforated plate
MFT-LP (order no. 488565).
The fastening plate (6.5) for the rocker has
to be exchanged so that the guide rail can
be lowered to the angle stop in the standard
working position.
The new fastening plate is enclosed with the
angle stop.
10