Attaching Stand To Saw - ShopMaster Delta S36-295 Guide D'utilisation

ATTACHING STAND TO SAW

Place saw (A) on stand assembly, while aligning the
screw holes in the saw stand with the threaded holes in
the saw base (Fig. 6).
Tighten hex cap screws to secure stand assembly to
saw.
NOTE: Do not over tighten.
Saw as assembled (Fig. 7).
FENCE RAIL AND EXTENSION
WING ASSEMBLY
Attached fence rail (N), scale side up (16" side of scale
to the right), to the front of the saw using (4) M5 x 25mm
hex socket cap screws (i) as shown in Fig. 8, making
sure rail is properly seated on each rail support on the
front of the table.
Insert (2) remaining M5 x 25mm hex socket cap screws
(i) through the fence rail (N) and extension wing (M) and
secure with (2) M5 kep nuts (l) as shown in Fig. 9. Use
straightedge to ensure extension wing is level as shown
in Fig. 9a and 9b.
NOTE: Leave the screws loose enough to make
adjustments for leveling the extension wing (M) to the
table.
Attached extension wing (M) to the table with (3) M5 x
10mm (3/8 in.) hex socket cap screws (K) and (2) M5 flat
washers (J) as shown in Fig. 10.
NOTE: Leave the screws loose enough to make
adjustments for leveling the extension wing (M) to the
table.
Level the extension wing (M) to the table as shown
in Fig. 10a and 10b using a straight edge ruler, then
tighten (3) M5 x 10mm (3/8 in.) hex socket cap screws
(K) to secure the extension wing in place.
N
l
FIGURE
ASSEMBLY
i
M
9
A
i
a
K
b
12
FIGURE 6
FIGURE 7
RAIL SUPPORT
N
FIGURE 8
J
M
FIGURE 10
a
b