Riving Knife Adjustment; Riving Knife Alignment - ShopMaster Delta S36-295 Guide D'utilisation

RIVING KNIFE HEIGHT
ADJUSTMENT AND ALIGNMENT
To change the position of the riving knife, remove
the throat plate then raise the blade assembly to the
highest position by turning the height adjustment wheel
clockwise on the front of the saw.
To adjust the riving knife from one position to the other
(Through cut/Non-Through cut) raise the riving knife
lock lever to the up position to unlock the riving knife
(Fig. 37). Next, gently move the riving knife to the right
to disengage from the lock pins in the riving knife lock
assembly, then slide up and forward for Through cut
or down and back for Non-through cut until you feel
the lock pins engage the riving knife (Fig. 37). Riving
knife is marked with Through Cut and Non-Through Cut
position that align with the table surface when in the
correct position. Push the riving knife lock lever down to
lock the riving knife in place as shown in Fig. 37a. Riving
knife assembly should appear as shown in Fig. 37b.
Once riving knife is properly adjusted, re-insert throat
plate (Fig. 15).
Verify riving knife is secure and in line with the
y
blade.

RIVING KNIFE ALIGNMENT

Your riving knife may be out of alignment if your work
piece is hitting the riving knife after the cut or causing
some binding during the cut. When this condition
occurs you will need to make an adjustment to the riving
knife alignment. The following procedures in this section
will assist you with making adjustments to the riving
knife alignment.
Locating point for "THRU" CUT POSITION as shown in
Fig. 38 (Customer should adjust the riving knife in this
position when making "THRU" cuts.)
NOTE: You must locate the riving knife in this position
prior to making any alignment adjustments to the riving
knife alignment of the blade.
If a parallel adjustment is required, use Fig. 38 and Fig.
39 to make the following adjustments:
1. Loosen the 2 hex socket head screws (AA)
2. Tighten or loosen the adjustment screw (BB1) to
adjust the datum line if the riving knife to be aligned
to the blade.
3. Adjust set screw (BB2) and (BB3), to assist with
alignment of the riving knife to be parallel to the
blade.
4. Tighten hex socket head screws (AA).

RIVING KNIFE ADJUSTMENT

Be sure to reinstall blade guard assembly, anti-
y
kickback pawls when riving knife is in the through
cut position.
THRU-CUT
POSITION
BB2
BB1
CORRECT
POSITION
25
LOCK
LEVER
FIGURE 37
NON-THRU CUT
POSITION
AA
BB3
AA
FIGURE 38
PARALLEL
SHIFT
FIGURE 39
a
b