General Parts Knowledge; Assembly; Stand Assembly - ShopMaster Delta S36-295 Guide D'utilisation

BLADE GUARD
TABLE
SCALE
FENCE RAIL
HEIGHT
ADJUSTMENT
WHEEL
ON/OFF
SWITCH
BEVEL
LOCK
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents,
and the Hardware Contents.
When lifting saw, hold it close to your body while
y
lifting. Keep knees bent and lift with your legs, not
your back.
Fully assemble saw with stand assembly prior to
y
use.
Stand assembly is an integral and necessary part of
y
the support structure for this saw. Do not attempt
to substitute a table or other surface for the stand

assembly.

STAND ASSEMBLY

Assemble stand part 2 (I) through stand part 1 (H) that
has cross support as shown in (Fig. 1). Secure stand
assembly with M8 x 65mm hex socket head screw (d),
M8 spacer (c), M8 washer (b), and M8 lock nut (e). (Fig.
1)
NOTE: M8 spacer (c) is between stand part (H) and (I).
(Fig. 2) for correct stand parts setup.

GENERAL PARTS KNOWLEDGE

ASSEMBLY
Do not modify saw, or create accessories not
y
recommended for use with this saw.
Do not connect to power supply until assembly
y
is complete. Make sure power switch is in "OFF"
position before connecting to power supply.
Avoid contact with blade teeth. Keep blade stored
y
or lowered when possible.
10
RIVING KNIFE
ANTI-KICKBACK PAWLS
THROAT PLATE
RIP FENCE
PUSH STICK
BLADE WRENCHES
MITER GAUGE
BEVEL SCALE
STAND
d
c
H
FIGURE 1
e