ShopMaster Delta S36-295 Guide D'utilisation page 11

NOTE: Make sure that stand part 1 (H) and stand part 2
(I) are assembled in the proper orientation.
With assembled stand open, attach legs (J) to the stand
using (eight) M8 x 35mm carriage bolts (a) and (eight)
M8 lock nuts (e). Tighten lock nuts to secure legs to
stand (Fig. 3.)
NOTE: Do not over tighten lock nuts.
See finished assembly of stand in (Fig. 4).
NOTE:
Before assembling stand to saw, unlock bevel
lock, tilt blade/motor assembly and remove Styrofoam
piece from under saw motor. The bevel lock is the
handle located underneath the blade height adjustment
wheel (Fig. 5).
ASSEMBLY
H
I
J
11
H
I
CORRECT
FIGURE 2
e
FIGURE 3
FIGURE 4
FIGURE 5
INCORRECT
a
STYROFOAM