Attaching Stand To Saw; Height Adjustment Knob Installation - ShopMaster Delta S36-300T2 Guide D'utilisation

NOTE:
Before assembling stand to saw, unlock bevel lock, tilt
blade/motor assembly and remove Styrofoam piece from under
saw motor. The bevel lock is the handle located underneath
the blade height adjustment wheel (FIGURE 6).

ATTACHING STAND TO SAW

Place saw (A) on stand assembly, while aligning the screw
holes in the saw stand with the threaded holes in the saw base
(FIGURE 7).
Tighten hex cap screws to secure stand assembly to saw.
NOTE: Do not over tighten.
Refer to (FIGURE 8).
Extend the outfeed support to expose the four holes. On
the bottom of the outfeed support tubes. Insert four M5 x
16 Phillips head bolt (i) from underneath. Tighten with the
supplied Allen wrench. Repeat on the other side of outfeed
support
.
HEIGHT ADJUSTMENT KNOB
INSTALLATION
• Insert shoulder screw (f) into height adjustment knob (g)
as shown in (FIGURE 9).
• Tighten shoulder screw (f) with Phillips Screw driver into
Hand Wheel. Height adjustment knob should rotate freely
around shoulder screw when raising or lowering the blade
with the Height Adjustment Hand Wheel.
ASSEMBLY
A
f
12
FIGURE 6
FIGURE 7
i
i
i
FIGURE 8
g
FIGURE 9
i