Fault - Blanco BC PC 4200 Manuel D'utilisation Et D'installation

CLEANING THE WELL
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Apply a food-grade detergent to the inside of
the well.
TROUBLESHOOTING
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur
during use.
Faults
The heating elements do not
come on.
IT
The appliance does not heat
GB
up to the set temperature.
DE
FR
The control panel does not come
on.
ES
English
4 - Rinse the well with drinking water and drain
5 - Apply a specific product or a water and vinegar
6 - Rinse, empty and dry the well.

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
Electrical connection not made
correctly.
Safety thermostat tripped.
Thermocouple malfunction.
Electrical wiring not connected
correctly.
Electronic circuit board not
receiving electrical power.
Electronic circuit board damaged.
- 12 -
(see page 9).
solution to the well to remove the detergent res-
idues.
Check the connection of the
electrical wiring.
Carry out the appliance reset (see
Important
Contact
service.
Check the connection of the
electrical wiring.
Check the connection of the
electrical wiring.
Important
Contact
service.
6
Remedies
page 9).
the after-sales
the after-sales