Assembly - Columbus McKinnon Yale YC Serie Mode D'emploi

16
A unit changed without consulting the manufacturer must not be used.
Do not use the hoist for the transportation of people.
Do not use the threaded spindle for lifting and/or attaching loads by means of ropes, belts or
chains.
Only one beam may be transported at a time with the load lifting attachment.
Never reach into moving parts.
Do not allow the unit to fall from a large height. Always place it properly on the ground.
The unit must not be used in potentially explosive atmospheres.
A
SSEMBLY
Inspection of the supporting structure
The supporting structure has to be selected to ensure that it has sufficient stability and the
expected forces can be safely absorbed.
Make sure that no impermissible additional loading may occur as a result of fitting the hoist
(e.g. by side pull).
The selection and calculation of the appropriate supporting structure are the responsibility of
the operating company.
• Open the load lifting attachment by turning the spindle counter-clockwise until it can be set
down onto the beam.
• By turning the spindle clockwise, the load lifting attachment is closed. The clamping jaws
must fully reach around the edges of the beam flange so that the load points rest on the
surface of the beam flange.
• The load lifting attachment can be secured against unintended loosening or opening. To do
this, the threaded pin (Fig. 5, Pos. 11) which is fitted in the longitudinal axis of the tensioning
nut (Fig. 5, Pos. 8), must be tightened using a hexagon socket key. A copper flat on the tip of
the threaded pin prevents damage to the spindle.
• When removing the load lifting attachment, the threaded pin has to be loosened first.
• The load must always be hung in the centre of the shackle or the thinner portion of the
suspension bar.
©
2016 Columbus McKinnon Industrial Products GmbH