Single Distance Measurement Mode - Parkside PMML 5 A2 Instructions D'utilisation Et Consignes De Sécurité

- The batteries must not be empty. Empty
batteries are shown in the display
the battery symbol
- If a definitive measurement is not possible,
the display shows the "Err" information.
The measurement must then be repeated.
Single distance
measurement mode
1. Slide the function switch
DETECT" mode. The display
itself on. If display
on, briefly press the POWER button
to switch on the display
12
can switch between meter and feet /
inch. To switch between meter and
feet / inch, press and hold the MODE
button
urement unit
Note: The measuring unit
be changed after any measurement
by following above mentioned step 1.
- Measurements start from the meas-
urement starting edge
the bottom side of the product is the
24 GB/IE/NI
for 3 seconds. The meas-
10
will be changed.
22
.
to "MEAS /
9
switches
2
is not switched
2
2
can also
22
. It means,
1a
by
2
. You