Polaris P93 Guide Du Propriétaire page 12

Page 12
Figure 29. Roll Cleaner onto Place on the Caddy
5.3 Replacing the Brushes
The cleaner is fitted with PVC brushes. There are
''wear'' indicators on the brushes. To maintain cleaner
performance at its best you need to replace the brushes
as soon as one of the wear indicators has been reached
(even if the blade wear is not even). It is recommended
that you replace the brushes every two (2) years.
1. Lift the cleaner to a vertical position so that the
handle is up. Refer to Figure 30.
1
Figure 30. Cleaner in Upright Position
2. Separate the edges of the brush and undo the
tabs as shown in Figure 31. Remove the worn
brushes.
2
Figure 31. Undo the Tabs of the Brush
2
3. To install a new brush, position the new brush
on the roller with the spikes facing downwards.
Refer to Figure 32.
3
Figure 32. install the New Brush
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot. Refer to Figure 33.
4
Figure 33. Pull Tabs Through Each Slot
5. Use a pair of scissors to cut the tabs 3/4 inch
from the heel so that they are no higher than the
spikes as shown in Figure 34.
Figure 34. Cut Tabs
6. Repeat this procedure to install the second
brush.