Polaris P93 Guide Du Propriétaire page 6

Page 6
2. Position the bottom power cable hook as shown
in Figure 3. Place the cable hook plate opposite
the power cable hook. Secure using a screw and
tightening with the Torx
Refer to Figure 4.
3
Figure 3. Position the Bottom Power Cable hook
4
Figure 4. Secure the Bottom Power Cable hook
3. Secure the cable hook plate using two (2) bolts
and two (2) nuts and tighten with Torx wrench.
Refer to Figure 5.
5
Figure 5. Secure the Cable hook Plate
wrench.
®
2
4. Position the power cable hook and control unit
hook on the upper tubes as shown in Figure 6.
Make sure the upper tubes (handles) are in the
proper orientation.
Figure 6. Position the Bottom Power Cable hook
5. Secure the power cable hook and control unit
hook around the tubes using a screw and hand
tighten with the Torx wrench (supplied with
unit). Refer to Figure 7.
Figure 7. install the Power Cable hook and
Control Unit hook
6. Secure the control unit hook using two (2) bolts
and two (2) nuts and tighten with Torx wrench.
Refer to Figure 8.
Figure 8. Secure the hooks
8
9