Preparation Of Chassis - RCA RACE1202E Mode D'emploi

PREPARATION OF CHASSIS

GUIDE PANEL
1 1
Install the curtain (ITEM D) into the curtain sash(ITEM H), please note that the side with middle clip
should be put inside the curtain sash, after that insert the curtain clip (ITEM H) into the curtain sash, as
shown in FIG.5. Therefore after the two guide panels are assembled, keep them for later use.
2 UPPER GUIDE
Fasten the upper guide(ITEM E) on the top of the air conditioner with 4 screws (ITEM A) as shown in
FIG.6.
GUIDE PANEL
3
Pull the guide panels and make them fit into the T shape groove from the top down, then insert and push
the frame into the guides of the air conditioner, as shown in FIG.7.
FOAM STRIP
4
Cut the adhesive-backed foam strip(ITEM B) to the window width. Remove the backing from the foam
strip and attach the foam strip to the underside of the bottom window. (FIG.8)
FOAM STRIP
(ITEM B)
5 LOCATE THE UNIT IN WINDOW
Open the window and mark center line with pencil on the center of the inner sill, as shown in FIG.9.
FIG.6
FIG.8
FIG.5
T SHAPE GROOVE
INNER SILL
ROOM SIDE
INSTALLATION
FIG.7
CENTER
LINE
FIG.9
9 9