Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
At times using the high fan setting to circulate the room air may make it comfortable even though you
do not set the air conditioner to cool the air. This will save your cost of use.
2
Features
4
5
3
1. Cabinet
2. Upper guide
3. Operation panel
4. Horizontal louver blades
5. Vertical louver blades
Using the Air Conditioner
WARNING
To reduce the risk of fire, electric shock, or injury to persons, read the section of important safety
instructions before operating the appliance.
To begin operating the air conditioner after installation, follow these steps:
1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extension cord or an adapter plug.)
2. Turn on the power switch.
3. Select the cool mode.
4. Set the fan speed at the high level.
5. Adjust the air direction control tabs for comfortable airflow.
6. Once the room has cooled, adjust the set temperature and fan speed to the setting you find most
comfortable.
Note:
If the air conditioner is turned off, a "compressor protection circuit " is automatically self-activated. The
compressor cannot operate during a "compressor protection"condition. (This is normal) it may take 3
minutes before the "protection circuit" self-deactivates.
1
6
7
10
8
9
6. Guide panel
7. Front grille
8. Air filter
9. Inlet grille
10.Wheel
FIG.2
INTRODUCTION
7 7
Publicité
Table des Matières
