Remote Controller - RCA RACE1202E Mode D'emploi

REMOTE CONTROLLER

+
TEMPERATURE
ADJUSTMENT button
In cool mode every press of this
button increases the setting
temperature by 1 °F(1 ) . If it is
pressed continuously the temperature
will increase by 1 °F(1 ) every 0.5
second after 1 second. The range of
setting temperature is 61-88
(16-31 ) .
-
TEMPERATURE
ADJUSTMENT button
In cool mode every press of this
button decreases the setting
temperature by 1 °F(1 ) . If it is
pressed continuously the
temperature will decrease by 1
(1 ) every 0.5 second after 1 second.
The range of setting temperature is
61-88 °F(16-31 ) .
ON/OFF button
Turns unit ON/OFF .
OPERATION MODE
button
Press it to select the operation
mode:
COOL
FAN COOL
FAN SPEED button
Press it to change the fan speed
in the order of low-medium-high
-auto-low.
HEAT mode is not applied to cool only type .
For specific usage and function of all buttons, please refer to " OPERATION PANEL" on Page 12-14.
NOTICE:
1.To operate, the remote should be within 6 meters of the unit with a clear line of sight.
2.Remove the batteries if the remote controller is not to be used for long periods of time.
Signal ejecting window
It sends signals to the unit.
°F
°F
OPERATING INSTRUCTIONS
TIMER SET & TIMER
INCREASE button
Press it once, if the air conditioner is set timer
before the display will display the time of timer
and you can increase the time by pressing this
button ,if not, the timer function will be initiated
and "01" will be shown on the unit, which means
the time of timer is 1 hour. Every press of this
button increases the time by 1 hour(24hours
at most).If it is pressed continuously the time will
increase by 1 hour every 0.5 second after 1 second.
You can refer to the following:
quit timer function.
TIMER SET & TIMER
DECREASE button
1.Press it once, if the air conditioner is set timer
before the display will display the time of timer and
you can decrease the time by pressing this button ,
if not, the timer function will be initiated and"01" will
be shown on the unit, which means the time of timer
is 1 hour. When the timer is set 1 hour, press this
button again the timer function will be stop. 2. When
the time of timer is set by the button "
SLEEP
decrease the time by pressing this button. Every
press of this button decreases the time by 1 hour. If
it is pressed continuously the time will increase by
1 hour every 0.5 second after 1 second. You can
refer to the following: 24
timer function.
SLEEP button
Press it once to start sleep function
and press it again to stop sleep
function.
ENERGY SAVER button
Used it to initiate or stop energy
saver operation. It is only functional
in cool mode.
...
24
01 02
", you can
...
23 01 quit
15 15