Publicité
Les langues disponibles
Les langues disponibles
Operation of wireless remote control
About new function of defrosting
Under switch-off state, hold MODE key for 2 seconds to enter or exit defrost H1 function.
After being energized, the defrost H1 function is defaulted off. When entering defrost H1
function, the double-8 nixie tube will display H1 under switch-off state.When adjusting to
heat mode, the double-8 nixie tube will display in flash for 5 seconds at a frequency of 1
count / sec. After the flash is ended, the remote controller will display the preset heating
temperature. Within these 5 seconds, press of +, - or TIMER key will cancel the display H1,
while the double-8 nixie tube will display the preset temperature. To switch the display of
temperature between Celsius and Fahrenheit after entering defrost H1 function, the
temperature value to be switched will be displayed firstly before display of H1 after 5 seconds.
Changing batteries and notices
Slightly to press the place
to take out the back cover of wireless
remote control.(As shown in figure)
Take out the old batteries. (As show in figure)
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
Attach the back cover of wireless remote control. (As show in figure)
NOTE:
When changing the batteries, do not use the old or different batteries,
otherwise, it can cause the malfunction of the wireless remote control.
If the wireless remote control will not be used for a long time, please
take them out, and don't let the leakage liquid damage the wireless
remote control.
The operation should be in its receiving range.
It should be placed at where is 1m away from the TV set or stereo sound sets.
If the wireless remote control can not operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.
If the wireless remote control is lostor broken,
please use the manual switch button. At this time,
the unit will run at the Auto mode, but the temperature
and fan speed cannot be changed. The operation
was shown as below:
To open the panel, the manual switch is on the
displayer box.
Turn on the unit: At unit turned off, press the button,
the unit will run at Auto mode immediately.The
microcomputer will accord to the indoor temperature
to select (Cooling, Heating, Fan) and obtain the
comfortable effect.
Turn off the unit: At unit turned on, press the button,
the unit will stop working.
Emergency operation
Manual switch
Fig.3
Publicité
