Britax B-SAFE Guide De L'utilisateur page 17

• Place the base in the desired
location on the seat and press
the lower connectors onto the
adjacent LUAS anchors until a
click is heard.
NOTE: Pull the lower connector to verify
that it is secure.
• While pressing the base down
into the seat, pull up on the
LCS adjuster strap to tighten.
• Open the two portions of the
lock-off and route the excess
LCS strap webbing through.
• Close the top portion and then
the bottom portion of the lock-
off to secure excess webbing.
NOTE: Excess webbing can interfere
with the infant car seat connecting
correctly with the base. Excess webbing
should always be stored.
• Verify that the LCS strap is tight and that the base is secure.
The base is secure when it moves less than 2.5 cm (1 in.) front-
to-back or side-to-side at the vehicle belt path.
• Correct recline angle is achieved when the green markers on
the recline angle indicators are visible between the two lines.
Installing with Base
15