Publicité
Les langues disponibles
Les langues disponibles
•
Sand both lower elevons (part 10) to a 45° chamfer. Attach the elevons to the hull wing using full-length
strips of adhesive tape (Tesa-Film). IMPORTANT: the elevons must be free to move smoothly in both
directions. Note that the chamfer should be located on the top surface of the hull wing.
•
Cut an opening for the motor mount tube in the upper hull shell (part 11), using the marked lines inside the
hull shell as a guide. Take care to obtain as accurate a fit as possible. If you still end up with a gap, fill and
seal it using UHU por. TIP: the hole should be opened up more towards the bow.
•
Mark the centreline on the upper hull shell and the hull wing, then glue these two parts together using
UHU por, taking care to line up the centrelines.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! No liability for printing errors. We reserve the right to introduce modifications. Sous réserve de modifications! Nous ne sommes pas responsables
d'éventuelles erreurs d'impression!
#56543
21
08/2005
Publicité
