EqProfiles; InfraRedRemoteCodes; UpdateFirmwareOnSub; BootloaderMode - Monitor Audio CUSTOM Serie Guide D'utilisation Du Propriétaire

EQProfiles

Flat: This is the sweet spot between a flat extended response
and minimal use of DSP enhancement. A good starting point to
create your own custom EQ profiles from.
Music: Maximum low frequency extension to pick out the
fundamental frequencies of every musical instrument.
Movie: The same flat response with good sensitivity, but a
little more extension to create a balance between the explosive
and atmospheric moments of a good film.
Impact: Uses the maximum natural efficiency of the drivers
for explosive impact.

InfraRedRemoteCodes

The Subwoofer has discreet remote control commands for use
with universal remote controls. The commands follow the
standard NEC protocol.
Device Address: 0x7D
POWER
ON
OFF
MUTE
VOL_UP
VOL_DOWN
PRESET_1
PRESET_2
PRESET_3
PRESET_4
TOGGLE_SOURCE
VOLUME_SELECT
LPF_SELECT
PHASE_SELECT
6
0x48 DISPLAY
0xd1 ENCODER
0xf1 PRESET_SELECT
0x78 RIGHT_BUTTON
0xa0 LEFT_BUTTON
0x08 PLAY_PAUSE
0x28 TOGGLE_NIGHTMODE
0x58 NIGHTMODE_ON
0x88 NIGHTMODE_OFF
0xB8 ROOMEQ_ON
0x00 ROOMEQ_OFF
0x28 DISPLAY_ON
0xA8 DISPLAY_OFF
0xD8

UpdateFirmwareonSub

To update the firmware on the Custom Subwoofer, you will
need the SubConnect application. This is downloadable from
the Monitor Audio Website. Please follow the installation and
setup instructions with the application.
Once the SubConnect app has loaded and established
connection with the subwoofer, either by automatic detection
or by you manually pressing CONNECT, it will always check for a
firmware update. If it finds one, you will see the below image.

BootloaderMode

To get the Subwoofer into bootloader mode, you must first
turn the subwoofer off by the mains switch. When it has shut
down, (LED on the front has gone off) press and hold the PRESET
button while simultaneously turning the subwoofer back on.
0x30
All 4 preset LED's will be illuminated when it is in Bootloader
0xD0
mode.
0xB8
Now click on OK on the application. The "Status" will show
0xe0
that it is disconnected. Click on CONNECT and then when
reconnected, the pop up showing there is an update available
0xc0
will reappear. Proceed to Automatic Update.
0xd8
0xA8
0xd2
0xf2
0xd3
0xf3
0xd4
0xf4
CUSTOM SUBWOOFER