Smoking; Blower Operation - Timberwolf TF 100 Mode D'emploi

7.5

SmOkiNg

A properly installed appliance should not smoke. If yours does, check the following:
• Has the chimney had time to get hot?
• Is the smoke passage blocked anywhere in the appliance, chimney connector or chimney?
• Is the room too airtight and the air intake not connected to the outside? Try with a window partly open.
• Is the smoke fl ow impeded by too long a horizontal pipe or too many bends?
• Is it a weak draft perhaps caused by a leaky chimney, a cold outside chimney, too large a diameter of a
chimney, too short a chimney, or a chimney too close to trees or a higher roof?
7.6

BLOwEr OPErATiON

The TF100 comes with a circulation blower which is connected through a variable speed control mounted on
the rear panel of the furnace (lower right side corner). Once this control has been turned on (turn knob clock-
wise from its "OFF" position, note: fan speed is reduced as the knob is turned further in the clockwise direction)
cycling of the fan is controlled by a thermal switch located at the rear of the firebox. The fan will cycle on when
the firebox reaches 49°C (120°F) and off when the temperature drops below 39°C (102°F).
VARI-SPEED
BLOwER CONTROL
25
83.1
W415-1133 / A / 06.12.13
EN