Finishing; Secondary Air Tubes / Baffles Installation - Timberwolf TF 100 Mode D'emploi

18

5.0 FiNiSHiNg

EN
5.1

SECONDArY Air TUBES / BAFFLES iNSTALLATiON

The four secondary air tubes have been factory
installed. The front most tube has larger holes than
the rear three tubes.
• Carefully pivot the fibre baffles (F) up onto the
secondary air tubes as illustrated. Ensure that
the top baffles are pushed all the way to the
rear of the firebox, leaving a minimum of 1 inch
(25mm) gap along the front. This will allow the
flue gases to escape the firebox. Ensure over-
lap joint is tight as illustrated.
W415-1133 / A / 06.12.13
BAFFLE
SECONDARY
AIR TUBES
OVERLAP
JOINT