Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.12 BLOwEr ASSEmBLY rEmOvAL
turn oFF eleCtriCal poWer beFore serviCing this applianCe.
all Wiring Must be Done by a QualiFieD eleCtriCian anD shall be in CoMplianCe With
loCal CoDes. in the absenCe oF loCal CoDes, use the Current Csa C22.1
CanaDian eleCtriC CoDe (in CanaDa) or the ansi/nFpa no. 70 national eleCtriC CoDe
To remove the blower assembly for service or inspection, please refer to the following procedures.
1. Remove the two securing screws from the top of
the front lower panel.
2. Remove the cover from the junction box located to the right of the blower mounted on the rear panel
(squeeze the sides of cover towards each other and pull).
BLOwER
DIVISION
PANEL
MOUNTING
RAILS
WARNING
!
in The UniTeD sTaTes.
SECURING
SCREwS (2)
WARNING
!
VARI-SPEED
W415-1133 / A / 06.12.13
31
EN
CONTROL
LOwER
JUNCTION
BOx
Publicité
Chapitres
Table des Matières
Dépannage
