PIONEER DJ DDJ-WeGO4 Mode D'emploi page 4

Start up the system.
1 Turn on the power of the Android device.
2 Press the [STANDBY/ON] button of this unit to turn
on the power of the unit.
After the startup illumination ends, the unit is ready for use.
3 Turn on the power of the peripheral device (speakers
with built-in amplifier, power amplifier, etc.).
4 Launch WeDJ for Android.
After a while, the WeDJ and DDJ-WeGO4 connection screen appears.
If the connection screen is not displayed, disconnect the USB
conversion cable from the USB terminal of your Android device
and then reconnect it.
Checking the audio device settings
(only when Android 4.4)
1 Tap [ ].
4
En
2 Turn [Sprit Output] on.
Operation
Loading tracks into a deck
The following describes the procedure for loading tracks into deck 1 (left
side) as an example.
1 Turn the rotary selector to switch to the browse
screen.
2 Turn the rotary selector to move the cursor to
[TRACKS] in the browse screen.
3 Press the rotary selector to move the cursor to the
track list.
If the rotary selector is pressed while pressing the [SHIFT] button,
the cursor moves to the [Tag list] / [Track] / [Playlist] / [Artist] /
[Album] / [Recording] / [Playback history] selection areas in the
browse screen.
4 Turn the rotary selector to select a track in [Track] and
then press the [LOAD] button of deck 1 (left side).
The track is loaded into the deck.
5 Set the positions of the controls, etc., as shown
below.
Name of part
EQ (HI, LOW) controls
FILTER control
Channel fader
MASTER LEVEL control
Crossfader
Operation
Set to the center position.
Set to the center position.
Move it forward.
Rotate it clockwise until it stops.
Set to the center position.