Kärcher K 2.94 M Mode D'emploi page 9

plosive and poisonous. Do not use acetone,
undiluted acids and solvents as they are ag-
gressive towards the materials from which the
appliance is made.
!
Wear suitable clothing and goggles to protect
against back spray containing water or dirt.
!
Never leave the appliance unattended when it
is in operation.
!
Warning: This appliance was designed to be
used with detergents which are supplied or re-
commended by the manufacturer. The use of
other detergents or chemicals may compromi-
se the safety of the appliance.
Electrical connection
!
Make sure that the power cord or extension
cables are not damaged by running over, pin-
ching, dragging or similar. Protect the power
cords from heat, oil, and sharp edges.
!
Never use a defective power cord or extensi-
on cable! If the power cord is damaged it must
be replaced with a special power cord availa-
ble from the manufacturer or his customer
service.
!
Never touch the mains plug and the socket
with wet hands.
!
The connection between the power cord and
extension cable must not lie in water.
!
All current-conducting parts in the working
area must be protected against jet water.
!
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
!
The appliance may only be connected to alter-
nating current. The voltage must correspond
with the type plate on the appliance.
!
The minimum fuse rating required at the sok-
ket outlet is 10 A (slow-blow).
!
To avoid accidents due to electrical faults we
recommend the use of sockets with a line-side
current-limiting circuit breaker (max. 30 mA
nominal tripping current).
!
Warning: Unsuitable extension cables can be
hazardous. Only use extension cables out-
doors which have been approved for this pur-
pose and labelled with a sufficient cable
cross-section: 1 -10 m: 1.5 mm
10 - 30 m: 2.5 mm
!
The plug and coupling of the extension cable
used must be watertight.
!
Always fully unroll the extension cable from
the cable drum.
;
2
2
Safety devices
Safety devices prevent injury and may not be mo-
dified or bypassed.
Motor stop
If the lever on the handgun is released, a pressure
switch turns the high-pressure pump off and the
high-pressure jet stops. If the lever is pulled, the
pressure switch turns the pump back on.
Safety catch
The safety catch on the handgun prevents the ap-
pliance from being switched on unintentionally.
Commissioning and operation
Definition of abbreviations used:
HP = High pressure
DT = Detergent
Description of the Appliance
When unpacking the product, make sure that no
accessories are missing and that none of the pak-
kage contents have been damaged. If you detect
any transport damages, please contact your dea-
ler.
Illustrations on Page 2
1 ON/OFF switch for appliance
2 Power cord with plug
3 HP outlet
4 HP hose
5 Handgun with safety catch
6 Connection for water supply with filter
7 Coupling unit
8 DT tank
9 DT suction hose with filter
10 Spray lance with dirt blaster
11 Spray lance with HP-nozzle
12 Accessory mount
13 Trolley
Initial start-up
When the appliance is delivered, the HP hose and
handgun are not attached, this prevents buckling.
Please mount these before using the appliance
for the first time.
"
Push out the safety clip in the handgun using
e.g. a small screwdriver.
"
Join HP hose and handgun together.
"
Push clip in until it engages and check that it is
securely fastened by pulling on the HP hose.
"
Remove cable tie and unroll HP hose.
English
9