Publicité
Les langues disponibles
Les langues disponibles
USE LIMIT
Max. water temperature : up to 40 °C
Max. PH of pumped liquid : from 6 to 10 (Series TFX from 1 to 10)
Minimum submersion depth : motor completely submersed, except pumps suitable for operation in dry room.
MOTOR
Asynchronous,
3-phase motor with squirrel cage rotor, insulation class F (155 °C), IP 68 protection suitable for continuous or
intermittent working ; max. starting per hour: 20 up to 5,5 kW - 15 for high power.
ELECTRIC CABLE
For standard length and dimensions of the electric cable (type HO7RNF or equivalent) see table "TECHNICAL DATA"; in
case of higher length keep into consideration possible voltage drops. The pump can be supplied with different cables and
fitted for different connections (see electric connection digram).
WARNING ! Don't use the pump with damaged electric cable; even small cuts of external
sheath could allow liquid infiltrations in the motor casing with immediate damage of same.
Replace immediately damaged the cable before immerging and starting the electric pump.
In case of cable replacement check carefully that the rubber watertight bush is suitable for the new cable (see spare
parts list). In case of reutilization of same cable replace the rubber watertight taking that the same tighten the cable
in a point different from previous clamping.
Always protect cable ends in order to prevent any infiltration in the cable same and be sure that cable end is not
immerged in the water preventing infiltrations into the motor with consequent damage.
The pump can be carried and stored in vertical position (recommended position), or in horizontal position with cable wound on the
motor casing in order to reduce the risk of damages and avoiding eventual motor rolling.
In case of pumps stored after use, it's suggested to wash the pump with clean water and disinfectand product before storage.
CAUTION ! The pump must be always
placed on a firm surface for preventing
overturning. This is valid both for tran-
sport and installation.
port and installation.
WARNING ! To lift the pump use always grips, handles, bees or cricket.
Feeding cable and pipe must never be used for lifting the pump;
under tension, crushed or bent suddenly.
PRODUCT DESCRIPTION
HANDLING AND STORAGE
NOTE!
NOTE !
CAUTION!
Before lifting the pump check lifting
handle condition and sure make that
relevant screws are well tightened.
12
feeding cable must never be
Publicité
