tau ZIP Manuel D'emploi Et D'entretien page 16

For all operation types: If the leaf stops during the opening phase at a distance (see figure on the previous page) of less than 40 cm with
respect to a fixed obstacle (wall, pillar, etc.), a pneumatic edge must be fitted to the leaf or the fixed part as follows:
1 - if the obstacle is higher than it is wide apply the edge (for the whole length of the obstacle) at a height of between 40 and 60 cm from
the ground;
2 - if the obstacle is wider than it is high and is lower than 60cm apply the edge 5 cm from the upper edge of the obstacle.
CHARACTERISTICS, ADJUSTMENT AND INSTALLATION OF SAFETY DEVICES
Photocells :
• These are fitted at a height varying from 40 and 60 cm from the ground at a max. distance of 10 cm calculated from the edge of the
open leaf and from the edge of the closed gate.
Sensitive safety edge
• In the simplest cases there must be Normally Closed (NC) contacts;
• Minimum deformation must be at least 1 cm greater than the stopping distance of the gate from when the device cut in
Torque limiting device
• This must be adjusted so that the gate stops in the presence of a mechanical resistance of 150 N (about 15 Kg) measured on its edge
as long as the kinetic force of the leaf is not greater than 10J.
ZIP INSTALLATION (fig. 13)
1 Gearmotor ZIP
2 Electric locks
3 Pillars
4 Control unit
5 Aerial and flashing light
6 Photocells
7 Key selector
8 Main switch
GUARANTEE: GENERAL CONDITIONS
TAU guarantees this product for a period of 24 months from the date of purchase (as proved by the sales document, receipt or invoice).
This guarantee covers the repair or replacement at TAU's expense (ex-works TAU: packing and transport at the customer's expense) of
parts that TAU recognises as being faulty as regards workmanship or materials.
For visits to the customer's facilities, also during the guarantee period, a "Call-out fee" will be charged for travelling expenses and labour
costs.
The guarantee does not cover the following cases:
• If the fault was caused by an installation that was not performed according to the instructions provided by the company inside
the product pack.
• If original TAU spare parts were not used to install the product.
• If the damage was caused by an Act of God, tampering, overvoltage, incorrect power supply, improper repairs, incorrect installa-
tion, or other reasons that do not depend on TAU.
• If a specialised maintenance man does not carry out routine maintenance operations according to the instructions provided by
the company inside the product pack.
• Wear of components.
The repair or replacement of pieces under guarantee does not extend the guarantee period.
In case of industrial, professional or similar use, this warranty is valid for 12 months.
ZIP12 INSTALLATION (fig. 14)
1 Gearmotor ZIP
2 Electric locks
3 Pillars
4 Control unit
5 Aerial and flashing light
6 Photocells
7 Key selector
8 Main switch
The distance between the control unit and the motor must not exceed
10 – 12 m.
16