Power Off - geo-FENNEL FMR 700 Mode D'emploi

CONNECTION TO THE EXCAVATOR
The FMR 706 is equipped with screw clamps and strong magnets for the attachment.
POWER ON
Press the ON/OFF switch once – all LEDs are flashing.
After switching on the FMR 706 is it in the coarse detection mode.
Press the ON/OFF switch again to switch between the fine and the coarse detection mode.
FINE / COARSE DETECTION
Change the detection mode with the ON/OFF switch:
FINE = the 2 inner LEDs „A" are flashing 3 times
COARSE = the 2 outer LEDs „B" are flashing 3 times

POWER OFF

Press the ON/OFF switch for 2 sec. to power off the receiver.
LED DISPLAY INDICATION
If the two upper red LEDs are flashing
If the middle green LED is flashing
If the two lower red LEDs are flashing
DISPLAY FRP 707
Connect the FRP 707 and the FMR 706 by use of the connecting cable 14 to the sockets 8 and 9.
Fix the FRP 707 in the cabin of the machine. Now the receiver can be observed conveniently on the
display even if the position of the receiver is above the cabin.
The FRP 707 has no own power supply. It is powered by the FMR 706.
= move the FMR 706 upwards
= the FMR 706 is on level
= move the FMR 706 downwards
EN
11